Get started

Solar Eclipse Maps: Reading the Lines and Bands

A GridTicker strip showing a solar eclipse card, with a world map of the eclipse's path and the region that sees part of it, under the headline "One shadow. Every line read."

Solar eclipse maps show where the Moon's shadow falls on Earth. The narrow dark band is the path, where the Sun is fully covered (a total eclipse) or becomes a ring (an annular one). The much wider zone around it is where only part of the Sun is covered. Curved lines across that zone show how much is covered, and other lines show the time. Once you know which line is which, one map tells you whether an eclipse reaches you, how deep it gets and when to look.

This guide covers each part of a typical map, how a lunar eclipse map differs, and how to keep the eclipse that matters to your own place on a screen.

The two shadows on every solar eclipse map

The Moon casts two kinds of shadow, and every solar eclipse map draws both.

The path: the inner shadow

The inner shadow is small where it touches Earth. As the planet turns and the Moon moves, it sweeps out a long, thin track that is usually well under 200 miles wide. That track is the path, the darkest band on the map.

The central line

A thin line runs down the middle of the path. That is where the Moon passes most squarely over the Sun, and where totality or the ring lasts longest. The closer you are to that line, the longer it lasts. Near the edges of the path, it lasts only a short time.

The partial zone: the outer shadow

The outer shadow is huge. It covers a region thousands of miles across, and everyone inside it sees a partial eclipse: a bite out of the Sun. On the map, this is the wide, lightly shaded area around the path. Its outer edge is where the eclipse fades to nothing.

The curves inside the partial zone

Coverage lines

Inside the partial zone, curves usually run parallel to the path, each labeled with a number such as 80%, 60% or 40%. Each curve joins places that see the same amount of the Sun covered at the deepest moment. The numbers get smaller the farther you are from the path.

Check which measure the map is using:

For the same place, magnitude is a higher number than obscuration. A map labeled with magnitude can make an eclipse look deeper than the share of sunlight it actually blocks.

Time lines

Some maps add a second set of lines that cross the path. These mark when the eclipse is deepest along each line, or when it begins and ends. The shadow travels at well over a thousand miles an hour. On most maps it moves from west to east, so places at the eastern end of the path get their eclipse later in the day than places at the western end.

Sunrise and sunset curves

At the ends of the partial zone you will often see loops or teardrop shapes. These mark places where the eclipse is already underway when the Sun rises, or still going on when it sets. If you are near one of these curves, the eclipse happens low on the horizon, so a clear view to the east or the west matters more than anything else.

Reading the map for your own place

  1. Find your place relative to the path. Inside it, you see totality or the ring. Outside it, you see a partial eclipse.
  2. Find the nearest coverage curve. That tells you how much of the Sun will be covered at the deepest moment.
  3. Check the time lines. They tell you roughly when, and how high the Sun will be.
  4. Watch for sunrise or sunset curves. If one is near you, plan a spot with an open horizon.

For more on what each percentage looks like in the sky, see Solar Eclipse Path Map: How Much of the Sun You'll See.

How a lunar eclipse map is different

A lunar eclipse map looks nothing like a solar one, and mixing them up is common.

Solar eclipse mapLunar eclipse map
What it showsWhere the Moon's shadow falls on EarthWhere the Moon is above the horizon during the eclipse
ShapeA narrow path inside a wide partial zoneRoughly half the globe
Depends on your placeYes: how much and when change a lotMostly no: everyone who can see the Moon sees the same eclipse
TimingArrives at different places at different timesHappens at the same moment for everyone

A lunar eclipse is Earth's shadow falling on the Moon. Anyone on the night side with the Moon up can see it, so its map is about where the Moon is above the horizon.

Safety, whatever the map says

A partial eclipse at 90% coverage still leaves enough Sun to damage your eyes. Look at the Sun only through eclipse glasses or a proper solar filter, for the whole eclipse. A lunar eclipse is safe to watch with the naked eye.

Keeping the next eclipse on a screen with GridTicker

GridTicker is a live ticker that runs in a browser on a spare screen, a second monitor or a TV. Under Space, eclipses have their own feed, described in the guide's moon, eclipses and the rest of the sky section. For a solar eclipse, the card covers an eclipse of the Sun that can be seen from your place: how much of the Sun is covered, a reminder that it is safe only through eclipse glasses, and a map of its path across the world and everywhere that sees some of it. For an eclipse of the Moon in the next month, the card says when and where to look if the Moon is up for it at home, with a map of the half of the world that can see it and your place marked on it.

Everything is worked out for one place. You set it on the Space page under where you watch the sky from, by typing an airport code or using your browser's location. If you leave that blank, GridTicker uses your Flights location, and failing that your first weather place.

You can also turn on an alert for an eclipse that can be seen from home. It takes over the screen starting ten minutes before the moment and stays for twenty minutes. For a solar eclipse, it always says to look only through eclipse glasses. Each alert can be switched off on its own, and it only shows on a screen where the eclipse card is switched on.

You can set up your own strip and have the next eclipse for your place waiting on screen.